DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the interface is not specified, all existing interfaces will be displayed.
Example
This example shows how to display the MAC address learning status on all physical ports 1 to 10.
Switch# show mac-address-table learning interface ethernet 1/0/1-10
Interface
------------------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
eth1/0/9
eth1/0/10
Switch#
40-11
show mac-address-table notification change
This command is used to display the MAC address notification configuration or history content.
show mac-address-table notification change [interface [INTERFACE-ID] | history]
Parameters
interface INTERFACE-ID
history
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
State
--------
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
(Optional) Specifies the interface to display.
(Optional) Specifies to display the MAC address notification change
history.
510