Enhanced Transmission Selection (Ets) Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
34. Enhanced Transmission Selection (ETS)
Commands
34-1 ets willing
This command is used to enable the Enhanced Transmission Selection (ETS) willing mode for the Data
Center Bridging Exchange Protocol (DCBX) on the specified interface. Use the no form of this command
to disable the willing mode.
ets willing
no ets willing
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable willing mode for ETS configuration when running DCBX, which indicates that
the interface is willing to accept configurations from the remote switch.
DCBX is used by DCB devices to exchange configuration information with directly connected peers. The
protocol may also be used for misconfiguration detection and for configuration of the peer.
The willing mode indicates that the local port has been administratively configured to accept
configurations from the remote device.
Example
This example shows how to enable the ETS willing option at interface eth3/0/1.
Switch# configure terminal
Switch(config)# interface eth3/0/1
Switch(config-if)# ets willing
Switch(config-if)#
34-2 ets recommend
This command is used to configure the Enhanced Transmission Selection (ETS) recommendation on the
specified interface. This setting will be translated to a DCBX ETS recommendation TLV. The TLV is
encoded into each LLDP message and may be transmitted by a system in order to indicate a
recommendation on how ETS should be configured. Use the no form of this command to revert to the
default setting.
452