DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
36. Ethernet OAM Commands
36-1 ethernet oam
This command is used to enable the Ethernet OAM function on the specified port. Use the no command
to disable the function.
ethernet oam
no ethernet oam
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
After enabling this function on the interface, the interface will start OAM discovery. If the OAM mode of
this interface is active, it initiates the discovery. Otherwise, it reacts to the discovery received from the
peer.
Example
This example shows how to enable Ethernet OAM on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# ethernet oam
Switch(config-if)#
36-2 ethernet oam mode
This command is used to configure the Ethernet OAM mode on the specified port. To return to the default
settings, use the no form of this command.
ethernet oam mode {active | passive}
no ethernet oam mode
Parameters
active
passive
Default
Specifies that the port's Ethernet OAM mode is active.
Specifies that the port's Ethernet OAM mode is passive.
458