Show Gvrp Configuration - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# gvrp nni-bpdu-address dot1d
Switch(config)#

41-9 show gvrp configuration

This command is used to display the GVRP settings.
show gvrp configuration [interface [INTERFACE-ID [,|-]]]
Parameters
configuration
interface
INTERFACE-ID [,|-]
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command only displays GVRP related configurations.
Example
This example shows how to display the GVRP configuration for the global configuration.
Switch# show gvrp configuration
Global GVRP State
Dynamic VLAN Creation : Disabled
NNI BPDU Address
Switch#
This example shows how to display the GVRP configuration on interfaces eh3/0/5 to eth3/06.
Switch# show gvrp configuration interface eth3/0/5-3/0/6
eth3/0/5
GVRP Status
Join Time
Leave Time
Leave-All Time
Specifies to display the GVRP configuration. If the interface is not
specified, the GVRP global configuration is displayed.
Specifies to display the GVRP interface configuration. If the interface
ID is not specified, all interfaces are displayed.
(Optional) Specifies the interfaces used to display the configuration.
Specify a single interface or a range of interfaces, separated by a
hyphen, or a series of interfaces separated by comma.
: Enabled
: Dot1d
: Enabled
: 20 centiseconds
: 60 centiseconds
: 1000 centiseconds
521