D-Link DXS-3600 Series Reference Manual page 465

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to configure interface eth1/0/1 Ethernet OAM error frame period monitor
threshold to default value.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# no ethernet oam link-monitor error-frame- period threshold
Switch(config-if)#
36-7 ethernet oam remote-failure dying-gasp
This command is used to enable notifying the dying gasp event on the specified port. Use the no
command to disable the function.
ethernet oam remote-failure dying-gasp
no ethernet oam remote-failure dying-gasp
Parameters
None.
Default
The Ethernet OAM dying gasp event will be notified by default.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command used to configure the capability of the dying gasp event. If the capability for the dying gasp
event is disabled, the port will never send out OAM PDUs with the dying gasp event bit set when an
unrecoverable local failure condition has occurred.
Example
This example shows how to enable the notifying dying gasp event on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# ethernet oam remote-failure dying-gasp
Switch(config-if)#
36-8 ethernet oam remote-failure critical-event
This command is used to enable notifying the critical event on the specified port. Use the no command to
disable the function.
ethernet oam remote-failure critical-event
no ethernet oam remote-failure critical-event
465