D-Link DXS-3600 Series Reference Manual page 717

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
ipv6 mld query-max-response-time SECONDS
no ipv6 mld query-max-response-time
Parameters
SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The valid interface for this command is VLAN. This command controls the period during which the group
member can respond to an MLD query message before the router deletes the membership.
Example
This example shows how to configure the MLD query's maximum response time for VLAN 1000. It
configures the MLD query maximum response time value to 10 seconds.
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ipv6 mld query-max-response-time 10
Switch(config-if)#
64-6 ipv6 mld robustness-variable
This command is used to set the robustness variable used in MLD. Use the no form of this command to
revert to the default value.
ipv6 mld robustness-variable VALUE
no ipv6 mld robustness-variable
Parameters
VALUE
Default
By default, this value is 2.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Specifies to set the maximum response time, in seconds, advertised in
MLD queries. The range is from 1 to 25.
Specifies the robustness variable. The valid value range is 2 to 7.
717