DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to check the connectivity of the LSP for network 192.1.1.0/24.
Switch# ping mpls ipv4 192.1.1.0/24
Reply from 192.1.1.1, time<10ms
Reply from 192.1.1.1, time<10ms
Reply from 192.1.1.1, time<10ms
Reply from 192.1.1.1, time<10ms
Ping Statistics for 192.1.1.0/24
Packets: Sent =4, Received =4, Lost =0
Switch#
This example shows how to check the connectivity of the LSP for network 110.1.1.0/24.
Switch# ping mpls ipv4 110.1.1.0/24
Request timed out.
Request timed out.
Request timed out.
Request timed out.
Ping Statistics for FEC 110.1.1.0/24
Packets: Sent =4, Received =0, Lost =4
Switch#
67-29
router-id
This command is used to configure the LSR ID of the LDP. Use the no command to restore the LSR ID to
the default value.
router-id IP-ADDRESS
no router-id
Parameters
IP-ADDRESS
Default
None.
Command Mode
LDP Configuration Mode.
Command Default Level
Level: 12.
Specifies the IPv4 address that will be used as the LSR ID. The IPv4
address must be an IP address of an existing interface.
766