D-Link DXS-3600 Series Reference Manual page 730

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
Multiple ranges can be added to a multicast VLAN profile. The IP address ranges, specified in a single
profile, must be of the same address family.
Example
This example shows how to add an IPv4 range into the profile called "profile mv_profile1".
Switch# configure terminal
Switch(config)# mvlan group-profile mv_profile1
Switch(config-mvlan-profile)# range 225.0.0.0 225.0.0.5
Switch(config-mvlan-profile)#
65-11 show mvlan group-profile
This command is used to display the multicast group profile configuration.
show mvlan group-profile [PROFILE-NAME]
Parameters
PROFILE-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display all group profiles by not specifying the profile name.
Example
This example shows how to display all multicast VLAN profiles.
Switch# show mvlan group-profile
Profile Name
---------------------
mv_profile1
customer
IP6-TV1
IP6-SET
Total Entries : 4
Switch#
Specifies the profile name.
Multicast Addresses
--------------------------------
225.0.0.0-225.0.0.5
224.19.62.34 - 224.19.162.200
FF02::1:ff00:65
FF02::4:: - FF02::FF03
730