Show Ip Source Binding - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no ip source binding MAC-ADDRESS vlan VLAN-ID IP-ADDRESS interface INTERFACE-ID [, | -]
Parameters
MAC-ADDRESS
vlan VLAN-ID
IP-ADDRESS
INTERFACE-ID
,
-
Default
No entries are configured.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to create a static binding entry used for IP source guard checking. Use the no
command to delete a static binding entry. The parameters specified for the command must exactly match
the configured parameters to be deleted.
If the MAC address and the VLAN for the configured entry already exist, the existing binding entry is
updated. The interface specified for the command can be a physical port or a port-channel interface.
Example
This example shows how to configure an IP Source Guard entry with the IP address 10.1.1.1 and MAC
address 00-01-02-03-04-05 at VLAN 2 on interface eth3/0/10.
Switch# configure terminal
Switch(config)# ip source binding 00-01-02-03-04-05 vlan 2 10.1.1.1 interface
eth3/0/10
Switch(config)#
This example shows how to delete an IP Source Guard entry with the IP address 10.1.1.1 and MAC
address 00-01-02-03-04-05 at VLAN 2 on interface eth3/0/10.
Switch# configure terminal
Switch(config)# no ip source binding 00-01-02-03-04-05 vlan 2 10.1.1.1 interface
eth3/0/10
Switch(config)#

48-3 show ip source binding

This command is used to display an IP-source guard binding entry.
Specifies the MAC address of the IP-to-MAC address binding entry.
Specifies the VLAN that the valid host belongs to.
Specifies the IP address of the IP-to-MAC address binding entry.
Specifies the port that the valid host is connected.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces are allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No spaces are allowed
before and after the hyphen.
590