D-Link DXS-3600 Series Reference Manual page 481

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to create an ERP instance 1 in the physical ring named "major-ring".
Switch# configure terminal
Switch(config)# ethernet_ring
Switch(config-erp-instance)# instance 1
Switch(config-erp-instance)#
37-8 level
This command is used to configure the ring MEL value of an ERP instance. Use the no form of this
command to return to the default setting.
level MEL-VALUE
no level
Parameters
MEL-VALUE
Default
By default, this value is 1.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The configured ring MEL value of all ring nodes participating in the same ERP instance should be the
identical.
Example
This example shows how to configure the ring MEL value of ERP instance 1 as 6.
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring2
Switch(config-erp)# exit
Switch(config)# ethernet ring g8032 ring1
Switch(config)# sub-ring ring2
Switch(config)# ethernet ring g8032 ring2
Switch(config-erp)# port0 interface eth3/0/1
Switch(config-erp)# port1 none
Switch(config-erp)# instance 1
Switch(config-erp-instance)# level 6
Switch(config-erp-instance)#
37-9 sub-ring
g8032 major-ring
Specifies the ring MEL value of the ERP instance. The valid range is
from 0 to 7.
481