D-Link DXS-3600 Series Reference Manual page 539

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
No IGMP snooping multicast router port is configured.
Auto-learning is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. To specify a multicast router port, the
valid interface can be a physical port or a port-channel. The specified multicast router port must be
member port of the configured VLAN. A multicast router port can be either dynamic learned or statically
configured. With the dynamic learning, the IGMP snooping entity will learn IGMP, PIM, or DVMRP packet
to identify a multicast router port. If auto-learn is disabled, the multicast router port can only be statically
configured.
Example
This example shows how to add an IGMP snooping static multicast router port for VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping mrouter interface eth4/0/1
Switch(config-vlan)#
44-9 ip igmp snooping proxy-reporting
This command is used to enable the proxy-reporting function. Use the no form of this command to disable
the proxy-reporting function.
ip igmp snooping proxy-reporting [source IP-ADDRESS]
no ip igmp snooping proxy-reporting
Parameters
IP-ADDRESS
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. When the function proxy reporting is
enabled, the received multiple IGMP report or leave packets for a specific (S, G) will be integrated into
one report before being sent to the router port. Proxy reporting source IP will be used as source IP of the
report, Zero IP address will be used when the proxy reporting source IP is not set. Interface MAC will be
(Optional) Specifies the source IP of proxy reporting. The default value
is zero IP.
539