Show Lldp - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# interface eth2/0/1
Switch(config-if)# lldp med notification enable
Switch(config-if)#
58-20 lldp subtype
This command is used to configure the subtype of LLDP TLV(s).
lldp subtype port-id {mac-address | local}
Parameters
port-id
mac-address
local
Default
The subtype of port ID TLV is local (port number).
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the subtype of LLDP TLV(s). A port ID subtype is used to indicate how the
port is being referenced in the port ID field.
Example
This example shows how to configure the subtype of the port ID TLV to mac-address.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp subtype port-id mac-address
Switch(config-if)#
58-21

show lldp

This command is used to display the switch's general LLDP configuration.
show lldp
Parameters
None.
Specifies the subtype of the port ID TLV.
Specifies the subtype of the port ID TLV to "MAC Address (3)" and the
field of "port ID" will be encoded with the MAC address.
Specifies the subtype of the port ID TLV to use "Locally assigned (7)"
and the field of "port ID" will be encoded with the port number.
660