D-Link DXS-3600 Series Reference Manual page 668

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
OID
Advertising Ports
Address 2 :
------------------------------------------------
Subtype
Address
IF Type
OID
Advertising Ports
Total Entries : 2
Switch#
58-25 show lldp neighbor interface
This command is used to display each physical interface's information currently learned from the neighbor.
show lldp neighbors interface INTERFACE-ID [, | -] [brief | detail]
Parameters
INTERFACE-ID
,
-
brief
detail
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command display the information learned from the neighbor devices.
Example
This example shows how to display information about neighboring devices learned by LLDP on eth4/0/9
in detailed mode.
Switch# show lldp neighbor interface eth4/0/9 detail
: 1.3.6.1.4.1.171.10.118.2
: -
: IPv4
: 10.90.90.90
: IfIndex
: 1.3.6.1.4.1.171.10.118.2
: -
Specifies the interface ID.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
(Optional) Specifies to display the information in brief mode.
(Optional) Specifies to display the information in detailed mode. If
neither brief nor detail is specified, display the information in normal
mode.
668