D-Link DXS-3600 Series Reference Manual page 569

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-if)# ip igmp enable
Switch(config-if)# ip igmp last-member-query-interval 2
Switch(config-if)#
46-5 ip igmp query-interval
This command is used to configure the interval at which the router sends IGMP general query messages
periodically. Use the no form of the command to revert to the default setting.
ip igmp query-interval SECONDS
no ip igmp query-interval
Parameters
SECONDS
Default
By default, this value is 125 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the IGMP group member query interval. The IGMP querier sends IGMP
query messages at the interval specified by ip igmp query-interval command to discover the receivers
attached to the interface interested in joining to multicast groups. Hosts respond to the query with IGMP
report messages to indicate the multicast group they are interested to join the membership.
Example
This example shows how to enable IGMP and configure the IGMP query interval to 300 seconds on
VLAN 1000.
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ip igmp enable
Switch(config-if)# ip igmp query-interval 300
Switch(config-if)#
46-6 ip igmp query-max-response-time
This command is used to configure the maximum response time advertised in IGMP queries. Use the no
form of the command to revert to the default setting.
ip igmp query-max-response-time SECONDS
no ip igmp query-max-response-time
Specifies to configure the interval at which the designated router sends
IGMP general query messages. The range is from 1 to 31744.
569