D-Link DXS-3600 Series Reference Manual page 383

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
server
Default
By default, this option is client.
Command Mode
DHCPv6 Guard Policy Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to specify the role of the attached device. By default, the device role is client, and
all DHCPv6 server messages that came from this port will be dropped. If the device role is set to server,
DHCPv6 server messages are allowed on this port.
Example
This example shows how to create a DHCPv6 guard policy and set the device's role as the server.
Switch# configure terminal
Switch(config)# ipv6 dhcp guard policy dhcpguard1
Switch(config-dhcp-guard)# device-role server
Switch(config-dhcp-guard)#
24-3 match ipv6 access-list
This command is used to verify the sender's IPv6 address in server messages. Use the no form of the
command to disable the verification.
match ipv6 access-list IPV6-ACCESS-LIST-NAME
no match ipv6 access-list
Parameters
IPV6-ACCESS-LIST-NAME
Default
By default, this option is disabled.
Command Mode
DHCPv6 Guard Policy Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to filter DHCPv6 server message based on sender's IP address. If the match ipv6
access-list command is not configured, all server messages are bypassed. An access list is configured
by the ipv6 access-list command.
server messages are dropped on this port.
Specifies that the attached device is a DHCPv6 server. DHCPv6
server messages are allowed on this port.
Specifies the IPv6 access list to be matched.
383