Ip Igmp Enable - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to disable checking the subscriber's source IP when an IGMP report or leave
message is received. Use the no form of this command to reset to the default setting.
ip igmp ignore-subscriber-ip-check
no ip igmp ignore-subscriber-ip-check
Parameters
None.
Default
By default, the switch will check the subscriber's source IP.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
By default, the IGMP report or leave messages received by the interface will be checked to determine
whether its source IP is in the same network as the interface. If they are not in the same network, the
message information won't be learned by the IGMP protocol.
Use the ip igmp ignore-subscriber-ip-check command to disable the source IP check. If the check is
disabled, the IGMP report or leave message with any source IP will be processed by the IGMP protocol.
Example
This example shows how to disable the subscriber's source IP check on VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip igmp ignore-subscriber-ip-check
Switch(config-if)#

46-3 ip igmp enable

This command is used to enable the IGMP protocol state. Use the no form of this command to disable the
IGMP protocol state.
ip igmp enable
no ip igmp enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
567