Ipv6 Source Guard Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

54. IPv6 Source Guard Commands

54-1 ipv6 source binding vlan
This command is used to add a static entry to the binding table. Use the no form of this command to
remove the static binding entry.
ipv6 source binding MAC-ADDRESS vlan VLAN-ID IPV6-ADDRESS interface INTERFACE-ID
no ipv6 source binding MAC-ADDRESS vlan VLAN-ID IPV6-ADDRESS interface INTERFACE-ID
Parameters
MAC-ADDRESS
VLAN-ID
IPV6-ADDRESS
INTERFACE-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to set the static manual binding entry of the binding table.
Example
This example shows how to configure an IPv6 Source Guard entry with the IPv6 address of 2000::1 and
MAC address of 00-01-02-03-04-05 at VLAN 2 on interface eth3.10.
Switch# configure terminal
Switch(config)# ipv6 source binding 00-01-02-03-04-05 vlan 2 2000::1 interface
eth3/0/1
Switch(config)#
54-2 ipv6 source-guard policy
This command is used to create an IPv6 source guard policy. This command will enter into the source-
guard policy configuration mode. Use the no form of this command to remove an IPv6 source guard
policy.
ipv6 source-guard policy POLICY-NAME
no ipv6 source-guard policy POLICY-NAME
Parameters
Specifies the MAC address of the manual binding entry.
Specifies the binding VLAN of the manual binding entry.
Specifies the IPv6 address of the manual binding entry.
Specifies the interface number of the manual binding entry.
623