D-Link DXS-3600 Series Reference Manual page 419

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays Distance Vector Multicast Routing Protocol (DVMRP) information on interfaces
on which DVMRP is active. You can use the show running-config to further check the DVMRP
configuration, if the interface is not displayed. If no interface is specified, all DVMRP active interfaces will
be displayed.
Example
This example shows how to display DVMRP configure information for interface 'vlan1000'.
Switch# show ip dvmrp interface vlan1000
NT = Neighbor Timeout
Interface
---------
vlan1000
Total Entries: 1
Switch#
28-6 show ip dvmrp neighbor
This command is used to display DVMRP neighbor information.
show ip dvmrp neighbor [INTERFACE-ID | IP-ADDRESS]
Parameters
INTERFACE-ID
IP-ADDRESS
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display DVMRP neighbor information. If neither the interface ID nor the IP address
is specified, information of all neighbors will be displayed
Address NT
--------------- ----
10.0.0.254 35
(Optional) Specifies the interface ID.
(Optional) Specifies the IP address of the neighbor.
Probe Metric Generation ID
----- ------ -------------
10 1 1234567890
419
State
------
Enabled