DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MLD snooping limit and access group information by command.
Example
This example shows how to display filter information when no interface is specified.
Switch# show ipv6 mld snooping filter
eth3/0/1:
Rate limit: 30pps
Access group: mld_filter
Groups/Channel Limit: Not Configured
vlan1:
Access group: Not Configured
Groups/Channel Limit: 25 (Exception List: mld_filter, exceed-action: drop)
eth3/0/3:
Rate limit: 20pps
Access group: mld_filter
Groups/Channel Limit: Not Configured
vlan1:
Access group: mld_filter
Groups/Channel Limit: Not Configured
vlan2:
Access group: Not Configured
Groups/Channel Limit: 100 (exceed-action: replace)
port-channel4:
Rate limit: 200pps
Access group: Not Configured
Groups/Channel Limit: Not Configured
Switch#
63-20
show ipv6 mld snooping groups
This command is used to display MLD snooping group-related information learned on the switch.
show ipv6 mld snooping groups [IPV6-ADDRESS | vlan VLAN-ID]
Parameters
IPV6-ADDRESS
vlan VLAN-ID
Default
(Optional) Specifies the group IP address. If no IPv6 address is
specified, all MLD group information will be displayed.
(Optional) Specifies the VLAN interface. If no interface is specified,
MLD group information about all interfaces will be displayed.
710