D-Link DXS-3600 Series Reference Manual page 480

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the VLANs to be protected by the ERP instance.
Example
This example shows how to configure the service protected VLAN as 100 to 200 for ERP instance 1.
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring2
Switch(config-erp)# instance 1
Switch(config)# ethernet ring g8032 ring1
Switch(config-erps)# sub-ring ring2
Switch(config-erps)# exit
Switch(config)# ethernet ring g8032 ring2
Switch(config-erp)# port0 interface eth3/0/1
Switch(config-erp)# port1 none
Switch(config-erp)# instance 1
Switch(config-erp-instance)# r-aps channel-vlan 20
Switch(config-erp-instance)# inclusion-list vlan-ids 100-200
Switch(config-erp-instance)#
37-7 instance
This command is used to create an ERP instance and enter the ERP Instance Configuration Mode. Use
the no form of the command to remove an ERP instance.
instance INSTANCE-ID
no instance INSTANCE-ID
Parameters
INSTANCE-ID
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to create an ERP instance under a physical ring. Deploy multiple instances in the
same physical ring topology provide the load balancing capability. The ID of ERP instances in physical
rings of the system are global significant.
Specifies the identifier of an ERP instance. This value must be
between 1 and 32.
480