D-Link DXS-3600 Series Reference Manual page 699

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to configure the interval at which the MLD snooping querier sends MLD group-
specific or group-source-specific (channel) query messages. Use the no form of the command to revert to
default setting.
ipv6 mld snooping last-listener-query-interval SECONDS
no ipv6 mld snooping last-listener-query-interval
Parameters
SECONDS
Default
By default, this value is 1 second.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. On receiving an MLD done message,
the MLD snooping querier will assume that there are no local members on the interface if there are no
reports received after the response time. Users can lower this interval to reduce the amount of time it
takes a switch to detect the loss of the last member of a group.
Example
This example shows how to configure the last-listener query interval time to be 3 seconds.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ipv6 mld snooping last-listener-query-interval 3
Switch(config-vlan)#
63-6 ipv6 mld snooping mrouter
This command is used to configure the specified interface(s) as the router ports or forbidden to be IPv6
multicast router ports on the VLAN interface on the switch. Use the no form of this command to remove
the interface(s) from router ports or forbidden IPv6 multicast router ports.
ipv6 mld snooping mrouter {interface INTERFACE-ID [,|-] | forbidden interface INTERFACE-ID
[,|-] | learn pimv6}
no ipv6 mld snooping mrouter {interface INTERFACE-ID [,|-] | forbidden interface INTERFACE-
ID [,|-] | learn pimv6}
Parameters
interface
Specifies the maximum amount of time between group-specific query
messages, including those sent in response to leave-group messages.
The range of this value is 1 to 25.
Specifies a range of interfaces as being connected to multicast-
enabled routers.
699