Monitor Session Source Interface - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to configure the RSPAN VLAN and destination port for an RSPAN source session.
Use the no form of the command to remove the configuration of the RSPAN VLAN.
monitor session SESSION-NUMBER destination remote vlan VLAN-ID interface INTERFACE-ID
no monitor session SESSION-NUMBER destination remote vlan
Parameters
session SESSION-NUMBER
remote vlan VLAN-ID
interface INTERFACE-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command on the source switch of an RSPAN session.
The monitor session destination remote vlan command configures the destination port used to
transmit the monitor packets and the RSPAN VLAN used to tag the monitored packets to the remote site.
For each session, only one destination interface can be configured. The destination port does not need to
be the member port of the RSPAN VLAN. The destination port can be either a physical port or a port
channel.
Each session should be configured with a unique RSPAN VLAN. The user cannot specify an interface for
the command to transmit the monitored packets for multiple RSPAN sessions.
Use the monitor session source interface command to configure the source ports whose packets will
be monitored.
Use the remote-span command in the VLAN configuration mode to specify a VLAN as an RSPAN VLAN.
The monitored packet will be tunneled over the trunk member port of the RSPAN VLAN in the subsequent
switches.
Example
This example shows how to create an RSPAN session on the source switch. It assigns VLAN 100 as the
RSPAN VLAN with the destination interface ethernet1/0/6 and three source ports (ethernet1/0/2 to
ethernet1/0/4) as the port being monitored.
Switch# configure terminal
Switch(config)# monitor session 2 source interface ethernet1/0/2-4
Switch(config)# monitor session 2 destination remote vlan 100 interface ethernet1/0/6
Switch(config)#

61-3 monitor session source interface

Specifies the session number for the port monitor session. The valid
range is 1 to 4.
Specifies the RSPAN VLAN used to tunnel the monitored packets to
the remote site. The valid range is 2 to 4094.
Specifies the interface to transmit the monitored packets to the remote
site.
684