Distance Vector Multicast Routing Protocol (Dvmrp) Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
28. Distance Vector Multicast Routing Protocol
(DVMRP) Commands
28-1 ip dvmrp
This command is used to enable DVMRP on the current interface. Use the no form to disable DVMRP on
the interface.
ip dvmrp
no ip dvmrp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The interface would start to run (or stop) the DVMRP protocol on the interface. Before enable the DVMRP
function on an interface, the user should enable IP multicast routing by using the ip multicast-routing
command in the global configuration mode. At most one multicast routing protocol can be enabled on one
interface. Make sure no other multicast routing protocol is enabled before enabling DVMRP otherwise; an
error message will be shown.
Example
This example shows how to enable the DVMRP protocol on the interface VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip dvmrp
28-2 ip dvmrp metric
This command is used to configure the metric associated with the route for Distance Vector Multicast
Routing Protocol (DVMRP) reports. Use the no form of the command to return to the default value.
ip dvmrp metric METRIC
no ip dvmrp metric
Parameters
METRIC Specifies the metric value. This value must be between 1 and 32. A
416