DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Administrators can enable the global GVRP state and individual port's GVRP state to start GVRP on the
port.
Example
This example shows how to enable the GVRP protocol global state.
Switch# configure terminal
Switch(config)# gvrp global
Switch(config)#
41-3 gvrp enable
This command is used to enable the GVRP function on a port. Use the no command to disable the GVRP
function on a port.
gvrp enable
no gvrp enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for both physical ports and port-channel interface configuration. This
command only takes effect for hybrid mode and trunk mode. This command does not take effect if the
Layer 2 protocol tunnel is enabled for GVRP.
Example
This example shows how to enable the GVRP function on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# gvrp enable
Switch(config-if)#
516