Ipv6 Route - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IPv6 Commands

ipv6 route

Configures a static entry in the IPv6 route. This command is currently not supported. Please use the new
ipv6 static-route command.
ipv6 route ipv6_prefix/prefix_length ipv6_address [if_name]
no ipv6 route ipv6_prefix/prefix_length ipv6_address [if_name]
Syntax Definitions
ipv6_prefix
/prefix_length
ipv6_address
if_name
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
Use the no form of this command to remove a static route.
Examples
-> ipv6 route 212:95:5::/64 fe80::2d0:95ff:fe6a:f458 v6if-137
Release History
Release 6.1; command was introduced.
Release 6.1.3; command was deprecated.
Related Commands
show ipv6 routes
MIB Objects
alaIPv6StaticRouteTable
alaIPv6StaticRouteNextHop
alaIPv6StaticRouteIfIndex
alaIPv6StaticRouteDest
alaIPv6StaticRoutePrefixLength
alaIPv6StaticRouteRowStatus
OmniSwitch CLI Reference Guide
IPv6 network that is the destination of this static route.
The number of bits that are significant in the iPv6 address (mask).
(0...128).
IPv6 address of the next hop used to reach the specified network.
If the next hop is a link-local address, the name of the interface used to
reach it.
Displays IPv6 Forwarding Table.
June 2012 page 15-21