Secondary Shaft Disassembly; Secondary Shaft Inspection - Honda S2000 Service Manual

1 .
Secondary Shaft Disassembly
Remove the tapered roller bearings using a
commercially available bearing separator and a
press as shown.
PRESS
Secondary Shaft Inspection
'1. Inspect
the gear surface and the bearing surface lor
w e a r a n d d a m a g e .
2. Measure the countershaft at points A, B, and C. lf
any part of the secondary shaft is less than the
service limit, replace it with a new one.
Standard:
A {Ball bearing contact area}:
31.002 - 31.013 mm 11.2205 - 1.2210 in.l
B {Plopeller shaft end tapered roller bearing
contact areal:
4 1 . 0 0 2 4 1 . 0 1 8 m m { 1 . 6 1 4 2 1 . 6 1 4 9 i n . )
C (Transmission end taper6d roller bearing
contact areal:
35.009 35.025 mm (r.3783 - 1.3790 in.)
Service Limit:
A: 30.95 mm {1.219 in.)
B: 40.95 mm {1.612 in.)
C: 38.94 mm {1.376 in.)
(cont'd)
13-45