07/11/02 09:19:19 61TA0000_110_0399
11. Jump the SCS line with the HDS.
12. Disconnect ECM/PCM connector B (49P).
13. Check for continuity between EVAP canister purge
valve 2P connector terminal No. 2 and body ground.
*03
EVAP CANISTER PURGE VALVE 2P CONNECTOR
Is there continuity?
YES
canister purge valve and the ECM/PCM (B3), then
go to step 24.
−
NO
14. Turn the ignition switch to LOCK (0).
15. Disconnect the EVAP canister purge valve 2P
connector.
16. Turn the ignition switch to ON (II).
PCS (YEL/BLU)
Wire side of female terminals
−
Repair short in the wire between the EVAP
Go to step 30.
17. Measure voltage between EVAP canister purge
valve 2P connector terminal No. 1 and body ground.
EVAP CANISTER PURGE VALVE 2P CONNECTOR
IG1 (BLK/YEL)
Wire side of female terminals
Is there battery voltage?
YES
−
Go to step 18.
−
NO
Repair open in the wire between the EVAP
canister purge valve and the No. 7 ACG (15 A) fuse
in the driver's under-dash fuse/relay box, then go
to step 24.
18. Turn the ignition switch to LOCK (0).
19. Jump the SCS line with the HDS.
20. Disconnect ECM/PCM connector B (49P).
*04
(cont'd)
11-399