Juniper ACX1000 Configuration Manual page 476

ACX Series Universal Access Router Configuration Guide
418
Configure the interfaces that participate in the VSTP instance.
3.
Enable configuration of the interface:
a.
[edit ... protocols vstp]
user@host# edit interface interface-name
Configure the interface priority:
b.
[edit ... protocols vstp interface interface-name]
user@host# set priority interface-priority
(Optional) Configure the interface as an edge port:
c.
[edit ... protocols vstp interface interface-name]
user@host# set edge
Enable configuration of a VLAN instance:
4.
[edit ... protocols vstp]
user@host# edit vlan vlan-id
Configure the bridge priority
5.
[edit ... protocols vstp vlan vlan-id]
user@host# set bridge-priority bridge-priority
For more information, see
Bridge" on page 406.
Configure hello BPDU timers.
6.
Configure the maximum expected arrival time of hello BPDUs:
a.
[edit ... protocols vstp vlan vlan-id]
user@host# set max-age seconds
Configure the time interval at which the root bridge transmits configuration BPDUs:
b.
[edit ... protocols vstp vlan vlan-id]
user@host# set hello-time seconds
(Optional) By default, the bridge port remains in the listening and learning states for
7.
15 seconds before transitioning to the forwarding state. You can specify a delay from
through seconds instead:
4 20
[edit ... protocols vstp vlan vlan-id]
user@host# set forward-delay seconds
"Bridge Priority for Election of Root Bridge and Designated
Copyright © 2017, Juniper Networks, Inc.