Interface - Juniper ACX1000 Configuration Manual

Configuring the PPP Password Authentication Protocol On a Physical Interface
Copyright © 2017, Juniper Networks, Inc.
When you configure an interface to use PAP, you must assign an access profile to the
interface. When an interface receives PAP authentication requests, the access profile in
the packet is used to look up the password.
To enable PAP, you must create an access profile, and you must configure the interfaces
to use PAP. For more information on how to configure access profile, see Configuring
Access Profiles for L2TP or PPP Parameters.
To configure the PPP password authentication protocol, on each physical interface with
PPP encapsulation, perform the following steps.
To assign an access profile to an interface, include the
1.
the
[edit interfaces interface-name ppp-options pap]
[edit interfaces interface-name ppp-options pap]
user@host# set access-profilename
To configure the name the interface uses in PAP request and response packets, include
2.
the local-name statement at the
hierarchy level:
[edit interfaces interface-name ppp-options pap]
user@host# set local-name name
You need to configure the password to be used for authentication. To configure the
3.
host password for sending PAP requests, include the
the
[edit interfaces interface-name ppp-options pap]
[edit interfaces interface-name ppp-options pap]
user@host# set local-password password
NOTE: By default, when PAP is enabled on an interface, the interface uses
the router's system hostname as the name sent in PAP request and
response packets.
To configure the interface to authenticate with PAP in passive mode, include the
4.
statement at the
passive
level:
[edit interfaces interface-name
user@host# set passive
Chapter 16: Configuring Point-to-Point Protocol (PPP)
[edit interfaces interface-name ppp-options pap]
[edit interfaces interface-name ppp-options pap]
ppp-options pap]
statement at
access-profile
hierarchy level.
statement at
local-password
hierarchy level:
hierarchy
497