Configuring A Layer 2 Protocol To Be Tunneled In Acx Series - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Configuring a Layer 2 Protocol to be Tunneled in ACX Series

Related
Documentation
440
Layer 2 Protocol Tunneling on ACX Series Overview on page 437
Layer 2 Control Protocol on ACX Series Routers on page 404
Enabling Layer 2 Protocol Tunneling on ACX Series on page 439
Configuring a Layer 2 Protocol to be Tunneled in ACX Series on page 440
Configuring Layer 2 Protocol Tunneling on ACX Series on page 441
You can configure L2PT only on Layer 2 ports. To configure L2PT, you must specify any
of the following protocols that is to be tunneled:
—Cisco Discovery Protocol.
cdp
—All versions of the spanning-tree protocol.
stp
—Tunnel the VLAN trunk protocol.
vtp
—Tunnel the IEEE 802.1X authentication
ieee802.1x
ieee802.3ah —Tunnel the IEEE 802.3ah Operation, Administration, and Maintenance
(OAM) link fault management (LFM)
—Tunnel the Ethernet local management interface protocol
elmi
lacp —Tunnel the Link Aggregation Control Protocol
—Tunnel the Link Layer Discovery Protocol
lldp
mmrp —Tunnel the Multiple MAC Registration Protocol
—Tunnel the Multiple VLAN Registration Protocol
mvrp
To specify the protocol that will be tunneled by the Layer 2 protocol tunneling, you can
include the protocol (cdp | stp | vtp | ieee802.1x | ieee802.3ah | elmi | lacp | lldp | mmrp |
statement at the
mvrp) [edit protocols layer2-control mac-rewrite interface ge-fpc/pic/port]
hierarchy level.
NOTE: When CDP, STP, VTP, IEEE 802.1x, IEEE 802.3ah, E-LMI, LACP, LLDP,
MMRP, or MVRP is configured for tunneling on a customer-facing port in a
provider bridge, the corresponding protocol should not be enabled for
operation on that interface.
Layer 2 Protocol Tunneling on ACX Series Overview on page 437
Enabling Layer 2 Protocol Tunneling on ACX Series on page 439
Configuring a Layer 2 Protocol Tunnel Interface in ACX Series on page 439
Configuring Layer 2 Protocol Tunneling on ACX Series on page 441
Copyright © 2017, Juniper Networks, Inc.