Disabling Mstp; Configuring Vlan Spanning-Tree Protocol - Juniper ACX1000 Configuration Manual

Disabling MSTP

Related
Documentation

Configuring VLAN Spanning-Tree Protocol

Copyright © 2017, Juniper Networks, Inc.
To disable the entire MSTP instance:
Include the disable statement. You can include this statement at the following hierarchy
levels:
[edit protocols mstp]
Layer 2 Control Protocol on ACX Series Routers on page 404
Configuring MST Instances on a Physical Interface on page 415
Configuring Multiple Spanning-Tree Protocol on page 413
Configuring Rapid Spanning-Tree Protocol on page 411
Configuring VLAN Spanning-Tree Protocol on page 417
Tracing Spanning-Tree Operations on page 421
You can configure the VLAN Spanning-Tree Protocol (VSTP) under the following hierarchy
level:
[edit protocols]
To configure the VLAN Spanning-Tree Protocol:
Enable VSTP as the version of spanning-tree protocol to be configured:
1.
[edit]
user@host@ edit ... protocols vstp
(Optional) For compatibility with older bridges that do not support VSTP, you can run
2.
force VSTP to run as the original IEEE 802.1D Spanning-Tree Protocol (STP) version:
[edit ... protocols vstp]
user@host# set force-version stp
NOTE: If VSTP has been forced to run as the original STP version, you can
revert back to VSTP by first removing the
the configuration and then entering the
protocol-migration
Chapter 12: Configuring Layer 2 Control Protocol
force-version
clear spanning-tree
configuration mode command.
statement from
417