Quality Of Service (Qos) - Dell Z9500 Command Reference Manual

Quality of Service (QoS)

The Dell Networking operating software commands for quality of service (QoS) include traffic
conditioning and congestion control.
This chapter contains the following sections:
• Global Configuration Commands
• Per-Port QoS Commands
• Policy-Based QoS Commands
Global Configuration Commands
There is only one global configuration QoS command.
qos-rate-adjust
Enable QoS rate adjustment to include overhead fields in rate metering calculations.
Z9500
Syntax
qos-rate-adjust overhead-bytes-number
Parameters
overhead-
bytes-number
Defaults QoS rate adjustment is disabled by default.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
Quality of Service (QoS)
Enter the number of bytes of packet overhead to include in
rate limiting, policing, and shaping calculations. The range is
from 1 to 31.
Description
Introduced on the Z9500.
43
1473