Section 400-Programming
System Configuration
Software Version: CPC-B Version 4.0 or higher
Address: FF1 8# 4# 1# 1# (0-8)#
Description
Use this address to identify the DBS system configuration in which the T1
interface is installed (DBS 40 by default).
This is one of the required addresses to make T1 operational. See
"Minimum T1 Programming" below for more information.
Programming
Table 1-36 System Configuration for T1 installation
Notes
Power-Cycling Requirement. For changes to this parameter to take effect,
the system must be turned off, then back on.
Minimum T1 Programming. The following table (see next page) lists the
programs that need to be set in order to make T1 operational. Default settings
appear in bold. In most cases, you do not have to change the defaults for any
remaining T1 programs.
DBS-2.3/9.2-400
FF1 8# 4# 1# 1# (0-8)#
Setting
0
DBS 40
1
DBS 72
2
DBS 96
3
DBS 40 + DBS 40
4
DBS 72 + DBS 40
5
DBS 72 + DBS 72
6
DBS 96 + DBS 40
7
DBS 96 + DBS 72
8
DBS 96 + DBS 96
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
System Configuration
Default: 0 (DBS 40)
(see table below)
Value
T1 must be in slave cabinet
T1 is not supported
T1 must be in slave cabinet
Notes
Page 1-137