Disconnect Timer; Table 1-38. T1 Disconnect Timer Values - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

Disconnect Timer

Software Version: CPC-B Version 4.0 or higher
Address: FF1 8# 4# 2# 2# (0-12)#
Description
Determines how long the DBS waits before sending a disconnect signal from
the T1 to the CO (200 ms by default).
NOTE: The CO Disconnect Timer (FF2 Trunk# 18# 0-15#) determines how
long the system waits to receive a disconnect signal from the CO.
Programming

Table 1-38. T1 Disconnect Timer values

Notes
Power-Cycling Requirement. For changes to this parameter to take effect,
the system must be turned off, then back on.
Page 1-148
FF1 8# 4# 2# 2# (0-12)#
Setting
0 150 ms
1 200 ms
2 250 ms
3 300 ms
4 400 ms
5 500 ms
6 1000 ms
7 1500 ms
8 2000 ms
9 2500 ms
10 3000 ms
11 3500 ms
12 Off (DBS does not automatically
send a disconnect signal)
DBS Manual - Revised April 2000
Section 400-Programming
Disconnect Timer setting
Default: 1 (200 ms) (see table below)
Value
DBS-2.3/9.2-400