Panasonic DBS-2.3-400 Programming Manual page 248

Chapter 1. System Programming (FF1)
Programming
Related Programming
Trunk Configuration: FF1 8# 4# (4 or 5)# 1# 1# (0 or 1)#
Number of T1 Channels: FF1 8# 4# (4 or 5)# 1# 2# (0-24)#
Trunk Circuit Type: FF2 (Trunk)# 21# (0-3)#
Notes
Loop-Start Card Version Requirement. This T1 Trunk Closure address
can only be used with the VB-43510A or VB-43511A versions of the loop-
start card.
CPC-B Versions Beginning With 6.03. The T1 Trunk Closure address is
no longer present. Instead, simply use the Trunk Circuit Type address (FF2
Trunk# 21#) to assign trunk ports as Loop Start, Ground Start, DID or T1.
Page 1-204
FF1 8# 7# (1 or 2)# (1-4)# (1-8)# (0 or 1)#
1=Master Cabinet
2=Slave Cabinet
DBS Manual - Revised April 2000
Section 400-Programming
Trunk Slot Trunk Port
on Card
0=Open
1=Close
DBS-2.3/9.2-400