Section 400-Programming
Programming and DISA Codes
Remote Programming ID Code
Software Version: All Versions
Address: FF1 4# (0000-9999)#
Description
The Remote Programming ID Code allows you to enter the terminal
programming mode. This programming mode is used to enter programming
commands from a remote PC or a local PC connected directly to the SMDR
port (CN6).
You can enter the remote programming mode through any of these three
methods:
• By dialing into the system through a direct DISA trunk
• By dialing into the system through a regular CO trunk, then requesting the
• By using a local PC and communications package to connect directly to
For more information on the terminal programming mode, see Appendix B.
Programming
To set the Remote Programming ID Code ...
To reset the ID Code to the default (9999)...
DBS-2.3/9.2-400
operator to enter the Remote Programming ID Code
the DBS serial port.
FF1 4# CONF ON/OFF
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
FF1 4# (0000-9999)#
4-Digit ID Code
Page 1-129