Disa End Time - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

DISA End Time

Software Version: All Versions
Address: FF2 (Trunk)# 20# (HHMM)#
Description
Use this address to program a DISA trunk to stop DISA operation at a
specified time each day. Trunks are enabled for DISA using the DISA Auto
Answer address (FF2 Trunk# 11#). Use this DISA End Time address, and the
DISA Start Time address (previous page), to limit DISA operation on a trunk
to a certain time period each day.
NOTE: The DBS will disable DISA to the trunk one minute after the time set
in this address. (For example, if DISA End Time is set to 0815, DISA will
actually end when the system clock reaches 8:16 a.m.)
Programming
To set the DISA End Time ...
Enter the time using the 24-hour format. For example, enter 0815 to set the
time to 8:15 a.m. DISA will actually end when the system clock reaches
8:16 a.m.
To clear the DISA End Time ...
Related Programming
Time Setting: FF1 1# 2# (HHMM)#
DISA Inbound Call ID Code: FF1 5# (0000-9999)#
DISA Outbound Call ID Code 1: FF1 6# 1# (0000-9999)#
DISA Outbound Call ID Code 2: FF1 6# 2# (0000-9999)#
DISA Auto Answer: FF2 (Trunk)# 11# (0 or 1)#
DISA Start Time: FF2 (Trunk)# 19# (HHMM)#
Notes
Caller ID Automatic DISA. This DISA End Time setting does not affect
Automatic DISA operation with Caller ID (program address FF1 2# 8# 1-10#
PhoneNo.#).
DBS-2.3/9.2-400
FF2 (1-64)# 20# (HHMM)#
Trunk Number
FF2 (1-64)# 20# CONF ON/OFF
DBS Manual - Revised April 2000
Chapter 2. Trunk Programming (FF2)
Time Setting (in 24-hr. format)
Default: **** (not set)
Page 2-17