Smdr Printing Mode 2: Long-Distance And Local Calls - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

SMDR Printing Mode 2: Long-Distance and Local Calls

Software Version: All Versions
Address: FF1 2# 2# 7# (0 or 1)#
Description
The SMDR data sent to Serial Port CN6 can be programmed to include both
local and long-distance calls, or it can be limited to long-distance calls only.
By default, both local and long-distance calls are included.
Programming
Notes
Bus Monitor Mode Interaction. If the DBS is switched to Bus Monitor
mode for troubleshooting, the SMDR mode must be reactivated to resume
SMDR output. The SMDR mode can be reactivated from any Attendant
phone by pressing ON/OFF - #93 - ON/OFF.
DBS-2.3/9.2-400
FF1 2# 2# 7# (0 or 1)#
0=Include long-distance calls only.
1=Include local and long-distance calls.
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
Page 1-61