Panasonic DBS-2.3-400 Programming Manual page 186

Chapter 1. System Programming (FF1)
STEP 10 -- OUTGOUNG SIGNALING TYPE
Address:
Description:
Options:
STEP 11 -- INCOMING SIGNALING TYPE
Address:
Description:
Options:
Page 1-142
FF1 8# 4# 6# (1-64)# 3# (0-2)#
Specify the outgoing signaling type used by the T1.
Be sure to match the signaling ordered from the CO.
For changes to this parameter to take effect, the system
must be powered down, then powered back up.
0 = Immediate Start
1 = Wink Start
2 = Dial Tone Start
FF1 8# 4# 6# (1-64)# 4# (0 or 1)#
Specify the incoming signaling type used by the T1.
Be sure to match the signaling ordered from the CO.
For changes to this parameter to take effect, the system
must be powered down, then powered back up.
0 = Immediate Start/Ringdown
1 = Wink Start
DBS Manual - Revised April 2000
Section 400-Programming
DBS-2.3/9.2-400