Table B-2. Codes For Switching Smdr/Bus Monitor Modes - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming
Resuming SMDR or Bus Monitor Mode After Terminal Programming
The DBS supports three remote functions --
However, only one of these functions can operate at a time. When not in
Terminal (Remote) Programming, either SMDR or Bus Monitor is active.
When you enter Terminal Programming (#6-xxxx), the other function stops.
When finished, the SMDR or Bus Monitor function resumes. The DBS can
be reset to the desired SMDR or Bus Monitor mode by entering (or having
someone at the site enter) one of the following codes at an extension or
Attendant phone:

Table B-2. Codes for switching SMDR/Bus Monitor modes

DBS-2.3/9.2-400
1) Bus Monitor
2) SMDR
3) Terminal (Remote) Programming
Command
#90 Normal Bus Monitor
#91 Register Bus Monitor
#92 Poll Bus Monitor
#93 SMDR Output
DBS Manual - Revised April 2000
Appendix B. Terminal Programming
Function
Page B-3