Dialing Plan Switch - Panasonic DBS-2.3-400 Programming Manual

Chapter 7. Toll Restriction (FF7)

Dialing Plan Switch

Software Version: CPC-A Version 4.0 or higher; CPC-AII/B Version 6.0 or higher
Address: FF7 1# 17# (0 or 1)#
Description
This address allows you to choose between the new North American
Numbering Plan (NANP) and the old dialing plan. By default, the old dialing
plan is used.
Selecting the new NANP dialing plan, in addition to supporting public
network changes in dialing formats, also provides greater flexibility for
"exceptions to the rule" -- such as applying TRS restrictions to individual
extensions, area codes, office codes, and country codes.
Specific differences between the old and new dialing plans are listed in the
table below. Some of the FF7 addresses in this chapter apply only to the new
NANP dialing plan; other FF7 addresses apply to both dialing plans, but the
value of their settings differs depending on the dialing plan selected. These
differences are noted in the explanation for each affected address.
Programming
Table 7-4. Differences between old and new dialing plans
Office Codes (Exchanges)
Long-Distance Calls
Equal Access Code Format
International Numbers
Related Programming
All Toll Restriction Addresses (FF7)
Page 7-10
FF7 1# 17# (0 or 1)#
Subject
NNX-XXXX
N0/1X-NNX-XXXX
10XXX
9 digits in length
DBS Manual - Revised April 2000
Section 400-Programming
0=Old dialing plan
1=New NANP dialing plan
Old Plan
(N=digits 2 thru 9
New (NANP) Plan
NXX-XXXX
NXX-NXX-XXXX
101XXXX
12 digits in length
X=digits 0 thru 9)
DBS-2.3/9.2-400