Second Attendant Position - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

Second Attendant Position

Software Version: CPC-AII (all versions) and CPC-B Version 2.0 or higher
Address: FF1 2# 1# 24# (11-69 or 101-699)#
Description
This address assigns an extension number as the Second Attendant position.
By default, the Second Attendant position is extension 101.
When all line appearances at the Primary Attendant are busy, calls will
transfer in sequence to the Second, Third, and Fourth Attendants. If all line
appearances are busy on all Attendants, calls will transfer to the Attendant
Transfer Extension (if assigned).
Programming
To assign a Second Attendant position ...
To clear the Second Attendant position ...
Related Programming
Extension Number Digits: FF1 2# 1# 12# (0 or 1)##
Third Attendant Position: FF1 2# 1# 25# (11-69 or 101-699)#
Fourth Attendant Position: FF1 2# 1# 26# (11-69 or 101-699)#
Attendant Transfer Extension: FF1 2# 1# 27# (11-69 or 101-699)#
Extension Numbers (assigning to ports): FF3 (ExtPort)# 1# (ExtNo.)#
Notes
Programming Restrictions. A telephone must be plugged into the Second
Attendant port before its extension number can be programmed or cleared.
Also, use another phone to program or clear its extension number (e.g., you
can't use ext. 101's phone to program ext. 101 as the Second Attendant
position).
Limitations on Assigning Attendant Phones. It is recommended that you
leave the Second Attendant at the default assignment (extension 11 or 101),
so that a DSS/BLF console can be used. System default for the Primary
Attendant phone is extension 10 or 100, assigned to port 1 -- and Primary
Attendant assignments cannot be changed.
Page 1-32
FF1 2# 1# 24# (11-69 or 101 to 699)#
FF1 2# 1# 24# CONF ON/OFF
DBS Manual - Revised April 2000
Section 400-Programming
Extension Number
(default: 11 or 101)
DBS-2.3/9.2-400