Table of Contents
Advertisement
Chapter 2. Trunk Programming (FF2)
Inbound Ring Pattern
Software Version: All Versions
Address: FF2 (Trunk)# 17# (0-9)#
Description
Each CO trunk can be assigned a distinctive ring pattern for easy recognition
of the trunk during an incoming call. Up to 9 different ring patterns are
available.
Programming
Table 2-1. Ring Patterns for inbound trunk calls
Notes
Transferred Calls. This setting does not affect transferred calls. The ring
pattern for transferred calls can be set in the Transfer Ring Pattern address
(FF1 2# 1# 31# 0-6#).
Precedence of Extension Ring Pattern Setting. The ring pattern (if any)
assigned to the extension (FF3 ExtPort# 39# Pattern#) will override this
Inbound Ring Pattern for incoming trunk calls.
Page 2-14
FF2 (1-64)# 17# (0-9)#
Trunk Number
Setting
Value
0
Synchronize (ring pattern determined by CO)
1
3 sec. on/1 sec. off
2
2 sec. on/2 sec. off
3
1 sec. on/1 sec. off
4
1 sec. on/2 sec. off
5
1 sec. on/3 sec. off
6
.5 sec. on/.5 sec. off
7
.5 sec. on/.5 sec. off/.5 sec. on/2.5 sec. off.
8
.5 sec. on/3.5 sec. off
9
1 sec. on/7 sec. off
DBS Manual - Revised April 2000
Section 400-Programming
Inbound Ring Pattern
Default: 0 (determined by CO)
(see the following table)
DBS-2.3/9.2-400
Advertisement
Table of Contents
