Pooled Trunk Access For Group "9 - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

Pooled Trunk Access for Group "9"

Software Version: All Versions
Address: FF2 (Trunk)# 3# (0 or 1)#
Description
Use this feature to place a trunk in a group from which trunks are
automatically chosen for outbound dialing. When you dial "9" from an SLT
or digital extension, or press an FF key that is set as a pooled trunk key, any
available trunk in the group will be accessed.
The trunk selection is made from the highest trunk number in the group to the
lowest.
Programming
Related Programming
LCR Access: FF1 2# 1# 3# (0 or 1)#
Notes
Interaction with LCR. Set the "LCR Access" option (address FF1 2# 1# 3#)
so that dialing "9" indicates a Pooled Trunk call. If this option is set so that
dialing "9" indicates an LCR call, trunk selection will default to pooled trunk
line access group 9 if all lines that could be used for LCR access are busy.
Required Hardware Setting. To use pooled trunks, Strap S1 on the CPC card
must be cut. See Section 300-Installation for instructions.
DBS-2.3/9.2-400
FF2 (1-64)# 3# (0 or 1)#
Trunk Number
0=Trunk is not included in access group "9".
1=Trunk is included in access group "9".
DBS Manual - Revised April 2000
Chapter 2. Trunk Programming (FF2)
Page 2-5