Table of Contents
Advertisement
Chapter 1. System Programming (FF1)
Door Phone Ring Timeout Timer
Software Version: CPC-AII and CPC-B, Version 7.0 or higher
Address: FF1 2# 9# (DoorPhone)# 5# (0-15)#
Description
This address sets the amount of time (in seconds) that a door phone will ring
an extension before it goes on-hook (extension stops ringing). This applies to
door phones connected to digital extension ports only (not trunk ports).
If the door phone caller re-initiates the call before this Timer is up, the Timer
will automatically reset and the extension will begin ringing again.
Programming
Table 1-8. Door phone ring timer values
Related Programming
Door Phone Ring Pattern: FF1 2# 9# (DoorPhone)# 6# (0-5)#
Notes
Reset Requirement. If changing the Ring Timer setting, activate the change
by unplugging the door phone from its port and plugging it back in.
Page 1-90
FF1 2# 9# (1-4)# 5# (0-15)#
Door Phone Number
(1-4)
Setting Value
0
5 seconds
1
10 seconds
2
15 seconds
3
20 seconds
4
25 seconds
5
30 seconds
6
35 seconds
7
40 seconds
DBS Manual - Revised April 2000
Section 400-Programming
Ring Timer
Default: 3 (20 seconds)
(see table below)
Setting Value
8
45 seconds
9
50 seconds
10
55 seconds
11
60 seconds
12
65 seconds
13
70 seconds
14
75 seconds
15
80 seconds
DBS-2.3/9.2-400
Advertisement
Table of Contents
