Attendant Intercom Calling - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

Attendant Intercom Calling

Software Version: All Versions
Address: FF1 2# 1# 14# (0 or 1)#
Description
Use this address to determine how intercom calls from an Attendant phone
are announced at extension phones -- by ringing the extension, or by
immediately establishing a voice path over the extension loudspeaker. By
default, a voice path is established when an Attendant dials an extension.
After the connection is established, the Attendant can change from voice to
ring (or vice versa) by dialing "1".
Programming
Related Programming
Alert Tone for Voice Calls: FF1 2# 1# 16# (0 or 1)#
Notes
Interaction With VAU. If this address is set to "Voice intercom calling" and
a VAU is used, the VAU will not answer a call from an Attendant unless the
Attendant dials a "1" after dialing the VAU.
Page 1-20
FF1 2# 1# 14# (0 or 1)#
0=Ring tone intercom calling from Attendant.
1=Voice intercom calling from Attendant.
DBS Manual - Revised April 2000
Section 400-Programming
DBS-2.3/9.2-400