Table of Contents
Advertisement
Section 400-Programming
Auto Flash Redial
Software Version: All Versions
Address: FF1 2# 1# 6# (0 or 1)#
Description
This address determines whether the DBS will send a "flash" signal to the CO
on loop-start trunks when the REDIAL key is pressed. By default, the
REDIAL key sends a flash before redialing a number.
If your DBS system is connected to a PBX, set this address to "0" (sending a
flash may place the line to the PBX on hold).
Programming
Related Programming
CO Flash Timer: FF1 3# 13# (0-15)#
PBX Flash Timer: FF1 3# 18# (0-10)#
Trunk Port Type: FF2 (Trunk)# 10# (1 or 2)#
Notes
Flash Timing. The CO Flash Timer (FF1 3# 11#) determines the duration of
a flash when REDIAL is pressed.
Ground-Start Trunk Restriction. The Flash and Redial features are not
functional for ground-start trunks. See Technote 13 (March 1992) for more
information.
DBS-2.3/9.2-400
FF1 2# 1# 6# (0 or 1)#
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
0=REDIAL does not send "flash".
1=REDIAL sends "flash".
Page 1-11
Advertisement
Table of Contents
