Table of Contents
Advertisement
Section 400-Programming
Serial Port Parameters (TTY Settings)
Parity Check
Software Version: All Versions
Address: FF1 2# 2# 1# (0 or 1)#
Description
This address determines whether the DBS checks parity over serial port CN6.
By default, parity checking is turned on.
If parity checking is activated, select the parity count -- "Even" or "Odd" -- in
FF1 2# 2# 2#.
Serial Port CN6 is normally used for SMDR.
Programming
Related Programming
Odd/Even Parity: FF1 2# 2# 2# (0 or 1)#
Notes
Checking Communications Parameters. If you later change this address
value, be sure to check all Serial Port addresses -- FF1 2# 2# 1# thru 9# -- to
make sure they are set properly.
DBS-2.3/9.2-400
FF1 2# 2# 1# (0 or 1)#
0=Turns off the parity check.
1=Turns on the parity check.
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
Page 1-55
Advertisement
Table of Contents
