Table of Contents
Advertisement
Section 400-Programming
FF Key Copy
Software Version: All Versions
Address: FF9 3# (ExtPort)# (ExtPort)##
Description
Use this address to copy the attributes of one extension's FF keys to another.
Copying must be done on an extension-by-extension basis. The first
extension port entry in this address is the FF key source; the second extension
entry is the FF key target.
Programming
Note: You must enter two pound-signs (##) at the end of this address.
Notes
Copying Restriction. This address does not copy FF keys programmed as
PSD (Personal Speed Dial) keys.
Clearing FF Keys Before Using the Copy Program. Before you copy the
FF keys to an extension that is set to the defaults, you must clear the key
settings of the target phone. To clear key settings, use address FF5 (ExtPort)#
(Key)# CONF ON/OFF.
Setting Up FF Keys on Multiple Phones. To set up multiple extensions with
new FF key settings, use the following steps:
1. Clear the keys of the source phone using FF5 (ExtPort)# (Key)#.
2. Copy the cleared key settings to multiple target extensions using FF9 3#
3. Set up the FF keys on the source phone using FF5 (ExtPort)# (Key)#.
4. Copy the new settings to multiple target extensions using FF9 3#
DBS-2.3/9.2-400
FF9 3# (1-144)# (1-144)##
(SourceExtPort)# (TargetExtPort)#.
(SourceExtPort)# (TargetExtPort)#.
DBS Manual - Revised April 2000
Chapter 9. Copy Program Settings (FF9)
Extension Port
Extension Port
(Source)
(Target)
Page 9-5
Advertisement
Table of Contents
