Table of Contents
Advertisement
Section 400-Programming
Automatic Night 2 Mode Start Time
Software Version: CPC-AII and CPC-B, Version 7.0 or higher
Address: FF1 3# 30# HHMM#
Description
In this address, you can activate a second Night mode by setting the
Automatic Night 2 Mode Start Time. This allows the DBS to switch from
Night to Night 2 mode automatically at the time set in this address.
You can program trunks to ring incoming calls at different extensions during
Day or Night mode (see FF4 addresses). And different TRS types can be
programmed for use in each mode (see FF8 addresses).
To set the automatic start time for Night mode, use FF1 3# 1# HHMM. To
set the Automatic Day Mode Start Time, use FF1 3# 29# HHMM.
Programming
To set the Automatic Night 2 Mode Start Time ...
To clear the start time (disable Night 2 Mode) ...
Related Programming
Time Setting: FF1 1# 2# HHMM#
Automatic Day Mode Start Time: FF1 3# 29# HHMM#
Automatic Night 1 Mode Start Time: FF1 3# 1# HHMM#
CO Ring Assignments: FF4 addresses
Toll Restriction: FF8 addresses
Notes
System Clock. The automatic start time for Night 2 depends on the DBS
system clock being set correctly.
DBS-2.3/9.2-400
FF1 3# 30# (0000-2359)#
FF1 3# 30# CONF ON/OFF
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
Night 2 Mode Start Time
(in 24-hour format)
Page 1-127
Advertisement
Table of Contents
